How To Test Rain Sensor

How to test wireless rain sensor.

How to test rain sensor.

It will be a small plastic box that receives the wires from the sensor. Before you start the test you need to enter the expected amount of simulated rainfall. Here are tips on how to test your rain sensor. Locate the rain sensor for your irrigation system.

When testing the sensor always use a manual all stations or manual program start under a manual single station start the rain sensor will be ignored and the sensor will not shut down the water. Turn on the time clock for the zone nearest the sensor. If the wipers do not move refer to your owner s repair manual for the location of the rain sensor module. Turn the rain sensor switch to the on position.

Rain sensor headlight sensor testing repair instructions fault diagnosis here you will find useful knowledge and handy tips relating to the rain sensor light sensor in vehicles. Most modules have location mounts on the firewall inside the engine. Check to make sure that the jumper tab also called a jumper wire was removed when the rain sensor was hooked up to the control panel. Check to make sure that the top of the sensor is not covered by eaves treetops or other obstructions that keep rain from reaching the sensor.

Typically it will be located on the roofline or atop a fence. Click the button for cal check expected rainfall to enter the expected rainfall amount. Things needed operator s manual for your irrigation system. Once the manual all stations is initiated go to the sensor and hold down the quick response spindle button and the water will shut down.